Gator FABRIC GF4.4

NON-WOVEN

PATIOS, WALKWAYS & DRIVEWAYS

100 LBF (1,459 kg/s²)

GF4-4-texture

INSTALLATION INSTRUCTIONS

Method of installation of GATOR FABRIC GF4.4 (100 lbf) for drainage and soil separation:

TYPICAL GRAVITY WALL SECTION AND PAVER
PLEASE NOTE
  • When excavation has been completed, leveled and compacted, lay the GATOR FABRIC GF4.4 covering bottom and sides of the excavated area.
  • Ensure the GATOR FABRIC GF4.4 is stretch to avoid any folds.
  • Always overlap the seams of geotextile by a minimum 12″ (30 cm).
STEP 1
Excavate the soil in the location of the project according to best practices.
STEP 2
With a rake, even out, level and compact the soil to a tolerance of 3/8″ (10 mm).
STEP 3

Apply GATOR FABRIC GF4.4 to the entire foundation and sides. Overlap seams by 12″ (30 cm) of the hardscape installation and trim to size.

STEP 4

Spread, level and compact your aggregate or bedding material when installing Gator Base and complete with your selected pavement.

Information regarding the physical properties, performance and permitted use of Alliance Designer Products Inc.’s Gator Fabric products is, to the best of our knowledge, reliable. However, Alliance Designer Products Inc. assumes no liability for the accuracy or completeness of this information or for its ultimate use. As Alliance Designer Products Inc. has no control over methods of use and field conditions, Alliance Designer Products Inc. disclaims all warranties, expressed or implied, including, without limitation, the warranties of merchantability and/or fitness for a particular purpose and as to quality. The final determination as to the appropriateness or suitability of any Gator Fabric product in any particular application rests with the end user and is the end user’s sole responsibility. This document should not be construed as engineering advice.